|
![](/i/fill.gif) |
3d3acf55@news.povray.org...
> I made an irregular spline that is half of a symetrical spline that I want
> to extrude. To get the second (right) half to match the first (left), I
> copied, pasted, and rotated to get two matching halves. I then welded the
> common center point. It appears to be one spline; I can select all the
> points and move it around, but when I click on "extrude", all the points
on
> the right side get de-selected, and only the left side will extrude. I've
> tried it several times in different ways, always with the same results.
What
> am I doing wrong?
Sometimes I get the same behaviour in Hamapatch.
One thing that usually works for this is:
When you got the half spline, clone it.
Then flip it in the axis you need to (model -> flip (whatever axis))
Close the spline.
Extrude it
Usually that works.
Hope this helps.
Txemi Jendrix
tji### [at] txemijendrix com
http://www.txemijendrix.com
Post a reply to this message
|
![](/i/fill.gif) |